![]() When you plug an electronic device into the USB cord the green LED light on the outlet will turn on, well at least with this particular outlet. Plug in a USB cord (or two) and test it out. Attach the receptacle to the wall box with the two screws (top and bottom).Īttach the USB outlet wall plate with a flat head screwdriver. Now, all of the wires should be connected to the receptacle.Ĭarefully put the wires and receptacle into the wall box. In this case, the black wires were connected with the black screw. In this case, the white wires were connected with the silver screw.Ĭonnect the black wires by inserting them and then tightening with a screwdriver. In this case, the ground wire was connected with the green screw.Ĭonnect the white wires by inserting them and then tightening with a screwdriver. If you purchase a different outlet yours may not be laid out or labeled like this one.īrad always connects the ground wire first because he thinks it makes connecting the other wires easier. Note: the picture below is of the specific USB receptacle outlet we used. Also, notice how the screws are different colors. ![]() The receptacle is labeled for which wires go where (there’s also instructions that will come with your receptacle). Grab your USB receptacle and start connecting the wires. Since it still works we’ll donate it to our local Habitat for Humanity ReStore so someone else can put it to use. We put everything in a plastic zip-loc bag. Straighten out the wires with your fingers or needle-nose pliers. The copper wire without insulation is the ground wire, which is a safety feature in case the hot or neutral wires come in contact with metal parts. And the two white wires are the neutral wires, which provide the return paths for the current provided by the hot wires. Notice how the wires have colored insulation? The two black wires are the hot wires, which provide 120VAC current sources. We just happened to start with the black wires. ![]() Note: there’s no particular order when it comes to disconnecting the wires. Grab the Phillips screwdriver and begin disconnecting the five wires (2 black, 2 white, 1 copper) by unscrewing the screws. Gently pull the receptacle out of the wall. There is one screw at the top and one at the bottom. Now, remove the original receptacle cover with a flat head screwdriver. When the night light went out we knew power wasn’t going to the outlet. For this particular project, Brad went out into the garage (where our circuit breaker box is located) with his cell phone and called my cell phone while I watched for the night light to go out. Since our circuit breaker box is so poorly labeled, and to be certain the power is off, we always do a little trick. If you’re questioning how you turn the power off you should probably abort this tutorial at this time. In our case, we went with an outlet with one standard plug and two USB ports, but they make outlets with two standard plugs and two USB ports in case you need two standard plugs.īegin by TURNING THE POWER OFF to the receptacle you plan to replace. Wire insulation stripper (may be necessary) So without further ado, how to install a USB wall outlet. But Brad mentioned how he wouldn’t mind having a USB outlet next to his side of the bed because when he has to charge his iPhone and our iPad it takes up both outlets, and he has to unplug the lamp. The only problem? I didn’t take any photos of us installing the USB receptacle. ![]() I posted a photo on Instagram, not thinking it’d be that big of a deal but people went bananas. One thing we decided to do was install a USB wall outlet so we could charge our iPhones and iPad in the kitchen. This past weekend Brad and I tackled some electrical work in the kitchen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |